Honda Prelude Online banner

type-s pistons in a h23a motor?

936 Views 3 Replies 2 Participants Last post by  Luder-xhpx
think it would work...?

the bore is the same on both the h22 and h23 so I would think it would fit... right?

the piston height/ valve clearance would be the only problem I would think.

anyone have any input?
1 - 4 of 4 Posts
G
I think someone else asked about this:

http://honda-acura.net/forum/Forum20/HTML/008606.html

I think the bore won't be a problem, but piston height might be. You would just have to measure the height of the piston at TDC, and see if there is any piston/valve interference.

------------------
Billy
North Texas Prelude Owners Group
www.ntpog.org
whoa, deja vu

jp
yeah I read and replied in that thread... thats what spark'd my sudden interest.

you could be able to run them without re-sleeve'ing the block if I use honda rings right?

[This message has been edited by Luder-xhpx (edited March 26, 2001).]
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top