Honda Prelude Online banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,336 Posts
Discussion Starter · #1 ·
Ok, I installed a quick release hub adapter and pinched the wire clean off to my horn button (which was working just fine before). I've since replaced the wire and the horn still doesn't work. I've changed the setup with how the horn button is held in the wheel, but shouldn't the connection be complete? How do those horn buttons work? Am I missing a ground?
 

·
Registered
Joined
·
1,336 Posts
Discussion Starter · #2 ·
Solved. The brass clip was not working because my quick release hub is part aluminum. I've hooked a ground wire from that to the metal boss on the center. It's all good.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top