Honda Prelude Online banner
1 - 11 of 11 Posts

·
Registered
Joined
·
1,369 Posts
make sure you got the right part numbers..

1155 for rear.. 97-00 prelude nonsh
1232 for front.. 92-00 prelude nonsh

if you ordered from shox.com, they screwed up on one of my friends' order, and sent him the 92-96 front shocks..

-bronx

------------------
<A HREF="http://www.bjunkyard.com" TARGET=_blank>

</A>
 

·
Registered
Joined
·
977 Posts
I got mine in today too, along with Ground Controls.


Quick question though. In the instructions for the GC's, it says for the rears to place the split rubber sleeve over an O-ring. When I do this, the GC sleeve doesn't go over it. What do I do?

Do I just leave off the O-ring? When I do this the sleeve is a little loose. TIA.
 

·
Registered
Joined
·
1,228 Posts
<font face="Verdana, Arial" size="2">Originally posted by rf7475:
I got mine in today too, along with Ground Controls.


Quick question though. In the instructions for the GC's, it says for the rears to place the split rubber sleeve over an O-ring. When I do this, the GC sleeve doesn't go over it. What do I do?

Do I just leave off the O-ring? When I do this the sleeve is a little loose. TIA.
</font>
hey, how much $ for the ground controls?? where at?

d

------------------
Resist, and you'll be overcome
 

·
Registered
Joined
·
1,228 Posts
thanks man...for those of you who have ground control coil overs, how do you know you have each corner adjusted to the right height? are there markers or what??

d

------------------
Resist, and you'll be overcome
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top