coppertone

sorry long post lots to explain h22 a wont start im pretty sure its a timing issue plz help all my info below plz help




ok i have a jdm h22 in 92 accord ex im running a 92-95 po6 p28 civic ecu chipped to run the h22. originall had the f22a6. during swap lengthened saudered shrink wrapped all wiring necessary hooked up map and all neccessary sensors. h22 stock injectors f22 fuel rail to compensate for jdm im using h22 fpr all vacuum lines seem to be correct using h22 dixxy jdm internal coil all wires plugs are good and hooked up right. i swapped to the f22 crank pulley bc the h22 one was to big to fit between the shock tower area and so i go to start it all up after fluids and it wants to start and it starts and runs for a sec occasionally then immediateley dies and sometimes spits air out the intake which leads em to believe its a timing issue. my dumb ass forgot to check it before dropping the motor in i made the assumption the motor came intact with dizzy and evertything as a whole the timing wld be fine since the timing belt isnt broken. i did swap the dizzy around for the coil conversion but im getting adequate spark and firing order on plug wires is right. installed brand new main relay fuel pump whines and cuts on so it has air and spark no vacuum leaks all hoses are good ggrounds are good its all good so it has to have splipped on the timing to wanna start and have compression run for a sec on some ocassions but immediately die and sputter out the intake i wld check the timing but if the crank pulley was swapped from the f22 the timing marks are probably useless so do i gotta retime everything how do i fix it plz help i wanna bring this muther ****er to life!!!!!!!!!