pics of my super-grippy pedals! - Page 3 - Honda Prelude Forum

Joon525 · 10-08-2002, 06:07 AM

Quote:

Originally posted by Kegster
I used the 4 screws (# 7 on the list) to screw down the plate in the middle to the metal gas padal... I just figured thats what your suppose to do, if you look a the instructions again you'll see a little drawing of a drill gun drilling into the pedal...

I also used the brackets like you did on top and bottom and the tape...

Kegster

The drilling was for another car, not the BB6, it can't hurt though. Look at the chart in the second picture. Notice the BB6 has a "B"....then look at the third picture......notice where I underlined "B" But like I said before, it can't hurt to drill.

Kegster · 10-08-2002, 01:32 PM

Quote:

Originally posted by Joon525

The drilling was for another car, not the BB6, it can't hurt though. Look at the chart in the second picture. Notice the BB6 has a "B"....then look at the third picture......notice where I underlined "B" But like I said before, it can't hurt to drill.

no wonder it was a pain in the @ss putting those screws in... I wasint suppose to.. hehe oh well..

Kegster

Joon525 · 10-08-2002, 06:23 PM

Quote:

Originally posted by Akimoto
Good stuff joon.

Question, is this reversible. Say if I was to go back to stock, could I attach the rubber pads back on the pedals?

Yes