DetroitStyle

I have had this for almost a week now. The black tail lights are now gone. I'm debating on using the cheap eBay slip overs for a temp. drop, or just wait until I order my Ksports.

Here are some specs on it.

Head:
Ported & polished
Ferrea Valves Stk size Exhaust/intake
New OEM Retainers
New Crower Valve Springs
New OEM Valve seals
New Valve retainers
New OEM Camshaft seals

Fully built Lower end F22b lower end:
Block Hot tanked/ Main bearing journals all line honed
Stock Bore JE 10:1 compression pistons Heat coated on side skirts and piston tops
Shot peened rods out of H23a1 balanced
Chromoly gap less rings
Crankshaft polished/balanced
OEM Rod Bearings
OEM Main Bearings
OEM Thrust washers
OEM Timing Belt
OEM Balance Shaft Belt
OEM New head bolts
OEM head gasket h23B1
OEM Oil Pump
New OEM Knock Sensor
New OEM Oil Pressure sensor
New OEM Oil Orifice
New OEM IAC Valve
NEW OEM Balance shaft seal w/ retainer
NEW OEM Crankshaft Seal
NEW OEM intake manifold gasket
New OEM Exhaust Manifold Gasket W/ 4-2-1 Header

BBYlude

is that The Village in Wixom?

__________________
**Erik**

DetroitStyle

No, I'm probably 20min away from Wixom though.

BBYlude

Commerce Twp. here! Nice to see a local yokel on here! welcome!

__________________
**Erik**

DetroitStyle

I'm in Waterford, so I'm not that far away.