bennettman2002

I am active military and am leaving and wont be able to take my car.
car is in San Diego CA
car has Oregon Plates
any question please email me


bennettman2002 AT yahoo . com

-I might not remember everything because there is a lot-

Exterior:

Enkei RS6 rims - 17x8
front- new Toyo proxes ZR rated
back- barely worn BF Goodrich G-forces
Wings West rear spoiler
shaved emblems
carbon fiber hood
30% tint all around
hid headlight kit

performance:

Eibach pro kit lowered 1" rear 1 1/2" front
DC sports strut bar (rear only)
DC sports 4-2-1 headers
High flow Cat
Tanabe cat back with low pro/high flow muffler
I.T.B.'s 50mm per cylinder (individual throttle bodies)
original intake manifold and AEM cold air intake included
fuel rail with adjustable fuel regulator
RC engineering 440cc fuel injectors
Walbro 650lph fuel pump
high output ignition coil
high output plug wires
NGK 4 prong spark plugs

Engine:

less than 1500 miles since rebuild
Brian Crower stroker kit: from 2.2L to 2.49L
-CP pistons high compression (11.5 : 1)
-89mm bore x 100mm stroke (darton sleeves) 55mm mains
-ACL race bearings
-billet crank
- H-beam BC625+ rods
Head ported and polished for best performance with natural aspiration by Abacus Racing
Race Engineering valves with 3 angle machining
titanium springs and retainers
Skunk2 stage 2 pro series cams
AEM adjustable cam gears
Kevlar reinforced timing belt
hardened oil pump gears
H23 manual timing belt tensioner

Hondata s300 piggy back ECU

P.S.
i have most of stock parts too

Attached Thumbnails