ZEX How-To-Install? - Honda Prelude Forum

telram · 01-12-2004, 12:06 AM

Anyone have a good ZEX How to Install? The one on Hondaprelude.com is no longer there unfortunately. Did anyone save it?

I've done most of my installation but want to see pics of the wiring. Namely, TPS sensor and 12v power source. Also, I need to see some pics of the Intake and FPR hoses. I just want to make sure I got everything right.

Thanks

telram · 01-13-2004, 06:31 PM

Ok,
I've gotten through most of the install without any problems. So here are a few specific questions that I still have pending:

1- What color is the TPS wire I have to tap into?

2- Is the harness that holds the TPS wire located on the firewall side of the TB?

3- Is the FPR the mushroom shapped object connected to the driver side of the Fuel Rail with a short hose going to the Intake Manifold?

Appart from that the install is fairly simple even for people who are not yet mechanically inclined like myself.

laughin2.2 · 01-13-2004, 06:38 PM

#3.
That sounds like the fpr. Does it also have a thick rubber hose going out the back of it and under the car(ie. fuel return line)? If so then that's the fpr.

toy4x4 · 01-13-2004, 07:10 PM

1-red with black stripe(middle wire of the 3 TPS wires)
2-yes
3-yes

telram · 01-13-2004, 09:01 PM

Thanks guys, can't wait to finish this install this weekend!

Swami · 01-23-2004, 07:29 AM

Im looking at doing this soon, and I am a major newbie.

How did it go?

Swami

telram · 01-25-2004, 01:23 AM

It went really well! I haven't tested it out yet since my car is in storage for the winter, but I did the test that is mentioned in the install instructions and everything seems to be fine.

The install was a lot easier than I thought it would be. It took me about 5 evening to do everything but only because I was working slowly. I can probably do it again in about 4-5 hours if I had to.