who here installed DP kit - Honda Prelude Forum

fliptout · 10-14-2003, 04:28 AM

i'm officially on the darkside

i have my NX kit sometime this afternoon. i'm debating on taking it to a shop OR save some $$$ and do the install myself. what tools would i need? i ordered 75 shot wet direct port. aside from the install itself, the direct port part is where i get lost. Is there a certain spot i drill to place the nozzle? id like to try and hide this kit, i seen a few direct port installs 19924ws, wreakdriver

this may be a weekend project since i have to take out the iM. Is there any write ups on direct port kits? any help is greatly apreciated

laughin2.2 · 10-14-2003, 07:52 AM

You'd need a drill, 1/4 tap, drill bit, solder, heat shrinking wrap, extra wire, teflon paste or loctite, wire cutter/stripper, and I think that's pretty much it. If you want to hide it it will have to go on the bottom of the mani.

fliptout · 10-17-2003, 03:10 PM

do you know the part number for the IM? i checked out hondaautomotive.com (i think that was the site) there are 2 part numbers. i just want the bottom half where i drill the holes.

laughin2.2 · 10-17-2003, 11:49 PM

no idea. Just go to a Honda dealership and they can look it up for you.