CHOWEYT3T4

i am currently running the aem pnp system,now i downloaded a map from aem which is similar in configuartion as to my car - parts,turbo etc.now hondata says that the H22a will run on the B16a map even the D16 map will work.now when i tried to run the map the car wouldnt even start......but when i ran the D16 map car ran had a few problems with idle,ran really rich.how come the other map they had for a greddy turboed B16a wouldnt run properly?????any one have any ideas????

__________________

LudeTec

Hey,
I have hondata, and I am currently running on a base b16 chip. It runs perfectly fine It should have worked. It at least should have started... Even if it was the wrong chip, it would have just ran like ****. Did it even turn over?
Josh

CHOWEYT3T4

no it didnt turn over just a whole lot of cranking but never turned.its bit of a mystery to me.another thing is i ran the d16 map and it was running really rich until i started to boost where it started to lean out.i took out my missing link and now when i start to boost the car feels like it stalls - you know kinda like when you first learned how to drive a stick and you let go of the clutch to fast and you put more gas but its the back and forth motion....am i detonating when this happens??????

__________________

clendaniel

One problem with the b16 maps is that they actually use injectors 1, 2, 4, 5 and not 1, 2, 3, 4 among other differences. If you want to use the b16 maps it'd be much easier to cut and paste the fuel and ignition portions of the b16 map into the 1020 base config.

--Ian