LuderSH

What do you think of your Apexi WS on a forced induction setup?

inlinefour

Well, the only reason I originally bought it was because I NEEDED some type of exhaust with my turbo setup. I didn't want to run around with stock piping. After using it, I grew to love the sound of it, it sounds close to stock, very sleeperish, especially on a turbo honda. It is is 60 mm piping, so it is about 2.36".

3" piping will greatly enhance my performance though, so I am looking into putting together a custom 3" mandrel bent cat-back system in the near future.

I might try to cram a 3" downpipe in too, but I doubt it will fit without cutting the hell out of something.

__________________

DirtyLude

I'll be working on a 3" donwpipe and custom header in the next couple weeks, I'll let you know what happens.

__________________
DirtyLude
Mark Higgins

Toronto Prelude Club
www.hondaprelude.to

LuderSH

What size is the stock piping?
And do you know if this is outside diameter or inside diameter?

inlinefour

I'm not sure what size stock piping is...too small though.

All aftermarket cat-backs available for the prelude are 60mm. The GReddy PE is 60mm with a small section of 70mm before the muffler.

__________________