vtecspd

Curious, are there any aftermarket endlinks for the front sway bar (92-96).

Also, how do you tighten the stock endlinks. The ball joint to the bar is no problem. It's the endlink to the lower control arm. Doing it the way the manual says, hold the endlink and tighten the nut to ~25 ft./lb. The last time I did that (years ago) the endlink broke before I got to the correct value. Since then I just tighten it until I see the lower bushing start to deform.

That's another thing, the lower bushing always compresses more than the upper one. What's with that. They are only separated by a little flange on the lower control arm.

Mugenlude

Not any that I know of, custom seems to be the only route. Here is a good thread about endlinks.

Make Our Own Endlinks???

__________________
Jason ------------------------- Sponsored by Bridgestone & RedShift Motorsports

'97 Prelude Base (retired to DD) | STS '89 Civic Si | ITA '89 Civic Si (repairing)
http://www.chicagolandpreludeclub.com | http://www.teamundercoatracing.com

Don't argue with stupid people, they will bring you to their level and beat you with experience.