ww rs kit problem - Honda Prelude Forum

XLerate9 · 08-29-2003, 03:31 PM

Ok here's my problem.... the corner under the turn signal on my front lip keeps pulling away and letting the kit sag... the double sided tape let go. I can tell that that spot is where the most torque is... I have it screwed in the wheel wells so it can't come off... but it looks like crap and I can't get it to stick.

Anyone else have this problem?? I think I'm gonna try putting a screw on the inside into the bumper on the lip part that the tape is on... to try to hold it up. I have some 3M emblem and plastic adheasive... and some more double sided tape... But I don't think either of them will do the trick. Anyone have any other ideas??

-Ryan

bsi · 08-29-2003, 06:12 PM

pm midknight-lude

CrazieLude · 08-29-2003, 09:35 PM

ok you need help making it stick. Use 3M adhesion promoter. you can only buy it from a 3M dealer (not any hardware stores). it works wonders! its like $7-12 for a little can that will be MORE than enough.

T

MidNKight-lude · 08-29-2003, 10:51 PM

thanks nick. haha

anywho. do you have any screw holding your lip onto the bumper? before you add the screw. because on mine, i actually have two screw holding the lip to the bumper beside the double sided tape. if your running only double sided, that is not safe. reasing being, that i can rip that ish off easy, and my tape is saggin

got to redo it. but the screws in my rear lip is holding on perfectly

yes my rear lip is held on by screws only

edit are you talkin about the front of the lip, closer to end bend that has very lil tape?? if so, mine is saggin right there, only thing to do is take off all the double sided tape, put some promotoer, and clean the surfaces and restick