mike3

Hey Im just finishing up my H22 swap and im wiring in Vtec. I have the wires run to the ECU except where the wires are supposed to go theres already wires in the harness. And they arent Vtec ones. Its a '93 Sr(si) Any help would be great.

preludatic

this may help... http://www.preludeonline.com/showpos...81&postcount=8

__________________

aneurysm

--Vtec wire can be found on the front side of the passenger-side strut tower. Its cliped to the metal in a single-wire molex plug(gray) The wire should be Green/YEL. The plug just sits there and goes to nothing.

--Vtec Oil press sw : is in a gray round molex plug on the passenger side against the firewall, right next to the underhood fusebox. Wire goes into one side of the molex plug (ECU side) but has no corresponding wire on the engine side. this is the main engine harness.

Just finish running the 2 wires and you're done! =)

brad

__________________
Mobile Electronics Guru
-------------------------------
95' Si with JDM H22A/P13 ECU & JDM Climate Control
04' Volvo S60-R (Daily Driver)