BlueLude1

Aite fellas lookin for a better way to do this. Last time I did this it was a pain in the ass and made a big mess. Anyway does the tranny drain like its suppose to while the car is on jack stands if they are level? or should I drop the car and then tilt it using the jack on the drivers side and then fill it by jacking it up on the passengers side?

Any suggests would be appreciated

Thanks
Dane

__________________
B]1992 Prelude VTEC[/b]

* JDM H22 w/ H22 Tranny
* Blue AEM CAI
* ACT HDSS
* Apex'i V-AFC
* Energy Suspension Master Kit w/ Rear Trailing Arm Bushings
* Energy Suspension Motor Mount Inserts
* NGK Blue Wires
* Fiberglass Spoon Replica Lip

 

Zimmlude

As far as I know (or have read out of the helms NE ways) you need to fill it with the car level. This is to make sure you fill it up enough and not too much. As far as draining, just take the fill plug out and the drain plug. Don't worry about the little bit left inside after it is drained. Then (this is where the car needs to be level) either rig up some tubing or something and fill the tranny up to the fill hole.

HTH

__________________
Jason

marshdoggg

ya i have this little hand pump made for that, it works pretty well, but it takes a while to fill up...
marsh

__________________
-Marshall-

ludeconduct.com northwest prelude owners group
my setup
my photography website