Whats the best way to bleed the clutch line? - Honda Prelude Forum

BlueLude1 · 04-23-2003, 01:07 AM

I am just finalizing my JDM swap but i need to bleed out the slave cylinder but I got a bubble in my line so its not the usual story where u just pump the pedal and bleed it out a couple of times and your ready to go. The clutch line on mine WONT PRESSURIZE I had this happen before when I replaced my Master Cylinder and slave cylinder at the same time but I had someone else fix the problem. Any suggestions would be appreciated.

Thanks
Dane

4bidden · 04-23-2003, 01:17 AM

Do what I told you, retard!

ExodusFX · 04-23-2003, 01:41 AM

LOL. Nice advice.

achemze · 04-23-2003, 02:02 AM

Yea! thats what PO is known for. Blunt, to the point answers. 'Follow instructions!'

BlueLude1 · 04-23-2003, 09:10 AM

haha hey man I am going to, but I wanted to have a back up plan incase that method doesnt work for me.

4bidden · 04-23-2003, 09:56 AM

Did it work?

BlueLude1 · 04-23-2003, 10:26 AM

no i cant move the slave cylinder cause i got all the radiator fans in the way

G_Loc · 04-23-2003, 11:43 AM

move the slave cylinder? er

I bled mine with no problem from the fans. Heck, I even replaced it, but the fan did get a little bit in the way there.

4bidden · 04-23-2003, 12:50 PM

Yea man, its not that hard. Just reach your hand down there and push the plunger looking thing back and forth. Dont be a wussy.

You should start to get pressure back in the pedal after about 20 pushes. Watch the reservoir for bubbles.