92-h23a1

I replaced all the gaskets on the valve cover. All the bolts. Everything! It's all from Honda too. But I have this problem. I check the back and it was fine, its just from the front two bolts. WHY?! The Oil Level is fine!!

__________________
H-Series

 

4thGenReady2Go

did you tighten them properly?

__________________

Senna: Another reason to own a Prelude.

92-h23a1

Yeah they were tighten fine because it was fine before, till recently when I started having radiator problems.

__________________
H-Series

eu4ik

take the nuts back off and make sure the rubber grommets are seated correctly. if you over torqued there could be cracks in the valve cover, but last time i overtorqued one of those, i broke the stud before anything worse happened. i think they only need like 10 pound feet.

if you find that the grommets are seated normally, hook it up with some grey rtv. when i popped my center stud i just sealed the hole with the washer and grey rtv. held fine til i got a new valve cover stud.

__________________
from the age of uniformity,
from the age of solitude,
from the age of Big Brother,
from the age of doublethink—greetings!