PRelude787

I'm installing Spoon strut bar. The little ABS line won't clear so I have to modify it. After modifying it it still pushes the brake line back and forces some pressure on it. Eventually it's gonna cause the ABS line to leak fluid.

I was thinking of just putting a rubber grommet on the area where the strut assembly touches the brake line. Hopefully this will solve the problem but I'd like to know what the rest of you guys did for this and what long-term effects it would have on the brake line it makes contact with.

__________________
96 Prelude Si

attilude93

If I remember correctly, I think I just coaxed the line to move a tiny bit to get the strut brace on. With mine anyways, I only had to move it a few millimeters so the brace would fit on the threads. Just make sure to be extremely careful when doing this so you do not break anything, becuase then you are in big trouble!!

__________________
Warning: Surgeon General states that this car will Smoke V8's!!

"But Officer its only a four cylinder!"

attilude93

here is a link which may be useful for ya......

Spoon Strut Tie Bar Install?

__________________
Warning: Surgeon General states that this car will Smoke V8's!!

"But Officer its only a four cylinder!"

PRelude787

thanx for the link....I searched and didn't see it

Now I just gotta figure out which plugs go where. I unplugged a couple to get the bar in but stopped what I was doing halfway cuz it got too dark and cold.....now my car won't start........I'll just see what happens tomorrow.

__________________
96 Prelude Si