rmiller

I'm trying to figure out why my light is on and I hit a bunch of brink walls:

the car is a 95 Prelude Si which has a passenger side Air bag. I picked up the car back in Dec and have done a motor swap and I'm onto the SRS system malfunctioning. Also, from what I can tell, the car has been in an accident with the front end being repainted.

When i try to ohm out the left or right dash sensors, I'm getting >3M ohms for the left and a complete open for the right.

I then tried to locate the suckers....I couldn;t find them. I pulled back carpet, I tore half the dask apart trying to follow wires, I can't find them.

From what I can tell from reading various forums is that they are round and should be on the inside of the firewall near the floor.

How big are they (1", 2",??)?
Where exactly are they located?

The other thing I beleive is that the SRS unit isn't the original but I can't tell for sure. Pulling the unit out and looking at the connector pin definitions linke VA, GND-A, GND-B, doesn;t look like they match the siring diagram.

Is there a place to determine SRS unit model numbers?

rmiller

Think I fixed it with a lot of help from other more knowledgable than I...

So the darn car doesn't have the sensor called out on the wiring diagram and just needed to have the MES (erase memory) done to it. The connector is right behind the center console right next to the check engine connector and the instructions are really simple to do - lots of writeup's out there for that.

Hope some in the future will catch this thread if needed....