neoGTR22

Am I correct to assume this should have been included? The engine looks immaculate from the outside (I'm assuming it was steam cleaned) with the exception of the harness, which was cut about 6 inches from the motor.

__________________
===Neil
85 BMW 535i
87 BMW 535is
05 BMW 330Ci zhp
92 Prelude Si JDM H22A w/tranny - SOLD

Dallicis

always r cut

__________________
1995 Red Prelude S-15.01 1/4 @ 92 MPH - Demoted to Daily Driver

and 1992 MR2 Turbo :-D

Zimmlude

It is useless to you anyways as it is from a JDM vehicle with the harness plugs on the wrong side of the car. Use you old harness (on you current engine) and just add the plugs needed.

__________________
Jason

neoGTR22

Cool, thanks for the response.

__________________
===Neil
85 BMW 535i
87 BMW 535is
05 BMW 330Ci zhp
92 Prelude Si JDM H22A w/tranny - SOLD

Lucke

since i picked my H22 up from them i got the full harness, but like they said, its useless to you. all you need are the sensors.

Absolut

I used my complete Si harness and connectors.

I also used the Si distributer and coil, VTEC injectors, Si upper coolant hose neck.
I added (stripped from the JDM harness) the 3 VTEC wires and connectors and threaded them into the Si harness.
AFAIK If your car is a 93-95 Si, you already have the vtec wires in the harness from the main harness connector down to the ECU. All you need to do is add the wire and connector from the engine to the main harness over by the ABS.

__________________
Jason