PatrickC1026

I just bought the 4bidden short shifter and will be installing this weekend. I heard that the plastic shift boot base has to be cut but I couldn't find any pictures where to cut (I HAVE SEARCHED!). I found these two pictures from NTPOG which is for 5th Gen shifter installation.



After cutting:


Is it pretty much the same for 4th Gen?

TIA.

__________________
'92 Si, Milano Red, >200K miles (Original front brakes)
AEM CAI, DC Headers, Greddy SP Cat-back Exhaust, MSD 8.5 mm Spark Wires, 4bidden Short Shifter, Neuspeed FSTB
17" ADR Skye7 Wheels, 215/40/17 Ventus H II Tires
Pioneer DEH-1500 Head Unit, Kicker 10" Subwoofer, Sony DCX-4120 Amplifier

---------------------------------------
'03 Honda Pilot EX-L, Silver
'03 Acura 3.2 TL Type S, Silver

red92si

All you have to do cut out the plastic in front of the shifter up to the staple that holds the boot on.

__________________

Tyler

i3luemrld

put your shift boot and cosole back on drive around the block go througfh all yer gears then take it back off and look at where the rubs are on the plastic cut and finished

__________________
Mike

Online Pictures Updated 12-9-04

4bidden

You dont have to remove much at all, and some people dont have to remove any at all. Picture where the linkage would hit when shifting into 3rd and 5th, and trim a bit there.

If you use the middle setting (C's setting) you might not have a problem, but if you move it to the top you will definately have to trim.

__________________
-Jeremy | Forbidden Motorsports

Yes....I'm back on PO!