iponnet

I need to remove my H23A1 engine, was wondering if it would be possible to remove it alone and keep the tranny in there? I already have the cylinder head, intake and exhaust manifold off and its basically its the block thats in there attached to the transmission!

Can I just unbolt the engine from the transmission and pick it out? Fwiw its a manaul transmission. Also is there something else besides the engine mounts I need to disconnect to separate the two?

any and all help and tips appreciated,

dshaw450

im pretty sure you can use that transmission i think thats what im gonna do for my h22a bc i just blew up my h23a1 but im not 100% sure but im pretty sure everything will match up

darkstar67

Id just pull block and trans. You just have to drop the axles, unhook your clutch lines and remove the mount. Ive gotten to the point where I can pull my h22 in about three hours.

__________________
ahhhh... I love this forum.

bthom88

do you have a poicture diagram of it so everyone can see i also am in the same problem as him i blew my h23 and i have a hoist just dont know exactly how to remove it

Sparky65

These engines are meant to be dropped out. In order to get it out of the top, you have to lift it up at an angle and slide it out very carefully. Also, it is easier to fully remove the engine mounts once you have the engine supported by other means.

__________________

-1993 Honda Prelude S streetcar
-1992 Honda Prelude Si racecar

bthom88

does enyone have a picture diagram