tommygun124

very stupid, but:

1. I can't get the bottom part of my momo shift knob to screw onto the top part of the shift knob for some reason i turn and turn and it doesn't go on (yes im going in the right direction). When I take the knob off the shifter it goes on fine...

2. My seat belt is ALWAYS twisted either at the shoulder or at the waist. I can't seem to fix it...

3. Was trying to fix my AC and when I put everything back together my antenna doesn't go up. I have a panasonic aftermarket head unit and the antenna is plugged into the headunit, what could be wrong?

Thats about all I know they're dumb but anyone have any tips?

__________________
You will be missed 95 Prelude


Anyone have a car to sell?

MR.CLIFFORD

Did you screw the little screws in evenly to allow your knob to tighten??

Don't know on the seatbelt.

Lots of possibilities on the antenna. My Mast is stripped so it doesn't go up. I just unplugged it cause I don't listen to radio. Can you hear the antenna motor turning??

__________________

QWITCHERBICHEN

SikRedRX-8

Nice ride, first time seeing it. Man I wish I only had the problems you had.

__________________
450awhp TB Evo VIII, G35 DD

tommygun124

the knob is tight but the bottom part doesn't fasten, thanks nice sig pic.... before i took out the ac the antenna would make noise struggle but it would work it has something to do w/ the wires or something....

__________________
You will be missed 95 Prelude


Anyone have a car to sell?

bk94si

The seat belt I think you have to unbolt it from the floor, flip it over and then bolt it back down.

__________________
Brian

Porschify

is the power antenna wire on your head unit connected to the corresponding wire on the wire hanress

__________________

[SUB[EX]

I grounded out my remote wire for my amp. and my antenna stopped working. Kinda wierd. I just checked the wiring and after that it was all good.

__________________
AIM:ISUBIEXI
S/SI/Vtec Hybrid. RS*R Header, JDM downpipe, Custom Downpipe back 2.25 Exhaust, Intake, ""Mugen"" Programmed p13, No balancer belt, no AC, Fidanza Flywheel, ACT clutch, SI trans, Power Slot rotors, SkunkII Coilovers, Enki Rims.

92 SI Ludester

my atenna used to make a grinding noise when it went up and down...after awhile it just stop working...so now i have to pull it up or push it down...i have a 12 disc changer so i have no use for my radio anymore so i put it down all the time now...looks better too

__________________