94_2.0i

I have the console with the lockable storage compartment. In the rear of the console between the back seats there´s a plastic cover that´s become undone on the passenger side.

The part I´m talking about is nr. 15 in this diagram :

http://www.hondaautomotiveparts.com/...ONSOLE+%281%29

The seats are blocking everything , so it´s kinda hard to see how I should get it back in place. On the upper part of it there´s a hole that probably should have a bolt in it , can anyone confirm this ? Also , on the lower part of this cover there´s a plastic pin that´s not secured in place , and I can´t find out where it should snap back into place ,anyone have a tip here ?
I guess a scan from a helms manual would be good for this

Thanks for any help

Arvid

mciampag

Take out the back seats and you'll be able to see what goes where real easily (or just fold down the leftside and take a look, the right side of that plastic piece is identical to the left). I can't remember if there's a bolt/screw at the top, but I DO know that plastic pin should be secured near the bottom. On the top edge there are two plastic clips that snap in place into holes just below the back deck.

__________________
- Mark

94_2.0i

Thanks for the help, just one more question. How do I remove the seat that can´t be folded down ?

red92s

Remove seat:
there are two plastic clips under the front edge of each seat bottom. Pull them towrds the front of teh car to release the seat bottom. The I think there is (2) 10 mm bolts that are holding the seat back in place (only accessible with bottom cushion removed).

Remove the driver side seat and fold down the pass side seat pack. there is a plastic cover around the pass-through hole, pull on it to remove it. There is no bolts holding that upper console piece on, it just clips on. There is a metal clip on the upper edge that locks into the rear deck and a plastic pin that goes through from either side.

__________________
7/20/2000 - 4/09/2007

Replaced with: "Zoom-Room"; 2003 Mazda Protege5

jpprelude

Start by taking out the fold down seat, and cushion. 2 clips and two bolts. Then take out the other seat, 2 clips and maybe one bolt You should be able to see how to take the lower middle piece out. After that, take out the upper middle piece


I took my interior out over a month ago, and can't remember step by step exactly.



It looks like the piece you are talking about has two plastic clips, 2 retaining clips, and maybe 2 screw, bolts.

If you want, I can take more pics.

JP