lude9285

how do i determine pin locations for on my p13 for the vtec wires and knock sensor.......does anyone have a diagram .....i know which pins the wires go to but need to identify which pins they are on the ecu

preludatic

so ur asking where the wires go into the harness?
__________

Swapping an H22 into an h23-equipped car, you will need to add:



VTEC solenoid, (signal=Green/Yellow to ECU Pin A4 )

VTEC pressure (oil pressure), (signal=Lt blue to ECU Pin D6 )

VTEC pressure (oil pressure), (ground=Black/Red )


Swapping an H22 into an f22-equipped car, you will need to add:



The wires listed above AND. . .

Knock sensor, (signal=Red/Blue to ECU Pin D3)

IAB, (signal=Pink to ECU pin Pin A17 ), (power=Blk/Yellow to 12v+ switched power source (hot with key in "on" or "start")

lude9285

thanks bro....haha its joel

yohan420

Back from the dead because this should be FAQ'D!

I checked the faq.. not there.. did a search .. whamo, perfect just what I needed. I'll be Vtec'n tomorrow.

__________________