sure I could help you out...
1. Parts included:
- 2 Window Visors (Left and Right)
- 8 Silver Screws (4 each)
- 8 Screws w/ black top ( 4 each)
- 8 Brackets (4 each)
- 2 Black Push Pins (1 each)
- 2 Brackets (1 each)
- 2 Pieces of Black rubber (1 each)
2. Tools needed:
- Philips Head Screw Driver
- Flat Head Screw Driver
- Surgical Gloves (to avoid fingerprints)
3. Steps:
a) Roll down the window and with the help of the flat screw driver and pulling with your hands remove the upper window trim, then remove the lower window trim, once done you will find 5 holes along the frame of the door.
b) Use the silver screws to mount the brackets as shown
c) Put the window trim back, make sure its properly secured otherwise there will be air and possible water leaks
d) Using the screws with the black top secure the window visor to the brackets placed along the door, (use gloves here so you don't leave your greasy fingerprints on the visors) be careful and do not tighten the screws all the way until you have placed the visor properly and the rubber trim is aligned with the door trim, you might use the flat screw driver to help align the rubber trim
After this you should have everithing almost finished, now there is the 2 brackets, the 2 pins and the 2 pieces of black rubber left,
I honestly don't know how to place those brackets, all i can tnik is to put the pins in the hole at the end of the visor, and bout the rubber I have no idea, if somebody knows please help me complete this write up, I hope this helps
Linear Mode
