Jkster

hey there. I was replacing my clutch, flywheel, and rear main seal. Finally have all that done and its time to reinstalll my half-shafts. the right side goes in and it is installed. But the left side (Driver side) halfshaft is in the tranny, and in the wheel hub...but WILL NOT go into the hole for the lower ball joint. Do you think i may have pulled the CV joint out of place? OR is there a way of reinstalling the halfshaft that i am missing? College is starting back up on monday so i am trying to get er done asap.

jsmooney

you could have separated one of the joints. take a look at it and you will be able to tell (the boot will be semi-stretched out.

Hopefully you have already fixed it by now.

if it is separated, you can put it back together, just twist it until it slides back in...