93bb1420

Ok i just got me a set of window visors for my 4th gen....It didnt come with the little screws so i am assuming i first need to get some from the local hardware store.....But i was trying to mock them up and i cant figure out how they would be installed.....if anyone knows of a write up or any link to send me to that would be great..thanks

93bb1420

anyone???

Crazi3ge3

double side tape. i used it on my 8th civic

mizlude

I could take one of my screw to a hardware store and see what he thread pitch is.
as for instaling them peal the window seal back and there are 4 holes the screw well screw into
put the tabs on, mark on the seal where they are at then use a knife and or razor to notch were the mounts are

S-LudeDan

Do you still have the clips?

To install the visors you have to remove the weather strip/seal. It's not hard at all. The install and Honda's intention is meant for your visors to be anti-theft.

If you only use 3M tape to install them, I will be stealing your visors tomorrow night. It will take me 2 minutes.

There are 100 threads online with DIY's on how to install the JDM visors. Search Google: "Installing JDM visors".

__________________

S-LudeDan

1. only a insert blank here can think of taping on a $200 dollar item.....to have it stolen the very next day.

2. JDM visors are installed with clips and screws under the weather strip. Why would someone want to go the cheap way by just taping them on?

__________________

93bb1420

yea ive been searching for install How to's but nothing for the 4th gen prelude...I had some on my crx but the install was different.....Yes my visors came with all of the clips and i will be getting the screws today.....Ok so i guess i will peel back the weather stripping and look for the holes to mount them up...sounds simple enough....and no i will not be using 3m tape for these because i dont want them to get stolen....

thiskid0001

if you can let me know what the screw sizes are cuz i need them too

93bb1420

well i dont know the screw size/thread pitch ...all i did was take my visor into "king bolt" here in cali....any hardware store should be able to find you some if you bring in the clips...

JDMugenBB1

Hope this helps... I know it's a big pic... but I wanted you to see what the Actual screws look like. These are new still wrapped.

__________________

JDMugenBB1

Their are a total of 4 mounting Brackets for screws that have two ends to them. One side is tapped & is tapered (flat head screw) & the other end is Oval (black rounded head screw)

The four with the Flat head are the ones that go screwed to the door frame & hold the mounting brackets To the Frame.

The Black rounded head ones, are the used hold the Visor TO the Bracket.

There is also one Single Bracket that is for the that goes on the top end of the visor (opposite of the mirror). The Visor is held in place to this bracket using the One Single Pop-In. This bracket does NOT get screwed in. As you can see, it only has one hole... which is for the Pop-in. The other end is bent it... so it grabs onto the frame.

Ceasar

__________________

JDMugenBB1

yay!

__________________

93bb1420

Is that a new set of visors???? if so where did you get them???.....i cant figure out where the last clip attaches to...ill probably end up mounting it up without using the last clip..

S-LudeDan

brand spanking new! nice! these are almost impossible to find brand new these days.

__________________

mizlude

I bet I know where he got them.

93bb1420

WHERE..I WANT SOME NEW ONES