so since my dad got laid off we are going to install all the stuff i have had laying around to install.
today i took it all out of the attic, inventoried all the parts i have to double check i have them all.
this project is going to start on Monday, because I'm off from work. i also will be off half of Tuesday all of wednesday all of thursday and all of Friday, i don't know how much will happen on Christmas eve and day. but i hope to have it done by next weekend.
we may also start the wiring for the 4ws while we have the dash out. ill put up pics of the parts later.
dash is out wiring is started
so what is completed so far is that the out side air temp sensor is inside the front bumper and the wires are run into the car, the power transistor and the blower motor high relay is wired up.
some more sensors are in but the big accomplishment is that the air mix motor is mounted and has a rod to make it work
all of the parts i used are parts that were on the usdm controls that are no longer needed since i have the jdm water valve which is electronically controlled rather than with a cable
didnt get a whole lot done last little bit to the blower motor high relay wiring, also got every wire thats already in the car tapped into the jdm plugs.
air mix motor
Linear Mode
