kpaii_t

Someone stole the bolts that hold the wheel hub to the table what size is it so i can get something that can at least hold my wheel on. also need the bolt size for the tie rod. please help lol

Its the bolt on the bottom. under the table. to hold it.

TJ97SH

I have no idea what the table is? I am assuming that you are not talking about the lug nuts? Maybe you should let us know what year and model your car is first.

Look at this picture:Honda Automotive Parts

Are you missing any of these parts? This is for a 94 Si. I picked something in the middle of the 4th gens since you didn't tell your model/year yet.

If you are missing part # 26, it doesnt matter. The wheel will hold the brake rotor on when it is locked down with the lug nuts. If it is something else, let us know the part #.

Look at this picture: Honda Automotive Parts

Is the control arm bolt you are missing one of these?

If none of this helps, try this link: Honda Automotive Parts

Put in the year, trim level, and emission type first. Then select the part category and look over the diagrams until you find the part you are missing. Lastly, place add it to your car. Repeat as necessary. Place order. Parts will be there via Fed Ex in about 5-7 days typically.

__________________


Travis James, EIT
travis.e.james@gmail.com

kpaii_t

I guess its a Arm outside quebec lol here its a table. But this is a pic of where it is that blue LINE is the wheel hub and the Bolt that needs the bolt im talking about.

Attached Thumbnails

 

TJ97SH

The part you are talking about is a bolt that is attached to the knuckle. If you are just talking about the nut that goes on the bolt (because the bolt is actually connected to the knuckle and couldn't have been taken off without removing the entire knuckle), it is part #17 in this picture: Honda Automotive Parts

You will also need a cotter pin (part #22). If you are missing the whole knuckle it is part #2 or #4 depending on which side its on. The knuckle is expensive. Hope this helps.

__________________


Travis James, EIT
travis.e.james@gmail.com

kpaii_t

thank you any idea what size it is so i can put a temp fix. i need to move the car but cant cause the wheels move out.

TJ97SH

No I am not sure what size it is. I don't have a 4th gen prelude anymore. It is probably the same as my '97, but I wouldn't know for sure.

You can try to put any nut you find on there. I am pretty sure the nut is a 17mm castle nut. If you can find one that fits that bolt, just put it on there until you can order the right part. You can get a nut from any hardware store. If you look at the bolt that it threads onto, you can count the number of threads per given length (I think this is called the pitch). If you go to a hardware store to get a temp. replacement, keep in mind that it is metric. They will probably try to give you a standard size nut with standard thread pitch.

If you are like me, though, you may have some extra Honda nuts and bolts laying around that you can use for now. That is your best bet.

__________________


Travis James, EIT
travis.e.james@gmail.com