lude9285

i swapped into my S prelude so i ran the 3 vtec wires + knock....i still need to run the IAB(butterfly valves right?)....i dont know where to run it from...i know what ecu pin it corresponds to.....is it that lil black box maybe ....with one sensor and and two vacuum lines?????
idunno?

red92s

The IAB harware is on the bottom/underside if the untake manifold on the drivers side.

The IAB system has two wires:
signal=Pink to ECU pin Pin A17 power=Blk/Yellow to any 12v+ switched power source

Both wires connect to the IAB solenoid valve. The solenoid is mounted to a small black plastic tank near the drivers side of the intake manifold.

__________________
7/20/2000 - 4/09/2007

Replaced with: "Zoom-Room"; 2003 Mazda Protege5

lude9285

ok...cool....thanks a lot