I know I know, another fog light thread

[Blamo]

This is on a 94. I have searched and am pretty confused on the whole matter. I plugged my generic relay into the fog light sub harness, I am positive it is it. The prewired wire colors for the switch are RED/YEL, ORG, and RED/GRN. The wire colors on the back of the switch are RED/YEL, BLK, and RED/BLK. I have wired them all ways, but only get anything with one of them.
When I have RED/YEL--> RED/YEL, ORG --> BLK, and RED/GRN --> RED/BLK wired up, and I push down the button the relay clicks and my light on the switch comes on, but no fogs. Then if I push the button again to turn it off, the relay doesn't click and the light stays on constantly on the switch. If I push the switch back down again the relay doesn't click. At first I was blowing the fog light fuse which is a 15AMP. I put a 20AMP in and it hasn't blown yet. Why is this happening? I even tried grounding BLK from the switch somewhere thinking maybe it wasn't getting a good ground, but same result. Any ideas on what to do? Thanks.

[chester]

Try this, Alex. The relay itself should be labeled.

30: 12v
87: nothing
87a: + on the fogs
86: 12v+ from your switch
85: ground

[natemanas]

my relay isn't labeled, and my fog switch (generic autozone POS) is in the center console..
I cannot figure out which wires to hook up to the switch.
I have red/green, red/yellow, and orange (with silver dots or something).
I've searched and searched, and found halfways answers that were never completed like 5 years ago...
Anyone able to help me?

[gotjnco]

DM PIN PLUG------EXTRA WIRE------------OEM WIRES FROM HARNESS
Red/Yellow-----------extra wire----------------Red/Yellow
Black-------------------extra wire----------------Red/Green
Red/Black------------extra wire----------------Orange

go ahead and connect the wires utilizing this connection guide.
For example, lets say you have the Red/Yellow side from the OEM harness. Since you extended this with the extra cable, take the end of the cable connected to the Red/Yellow OEM side and crimp it to the Red/Yellow cable from the JDM pin plug.

Do this for all three cables, making sure to match the colors correctly.

[natemanas]

hey thanks!