|
The front seats have only 4 bolts holding each in. They are at the corners of the seats, underneath small plastic covers. All you have to do is take those bolts out, and out comes the seat.
For the read seats, you must first take the bottom half of the seat off. to do this all you have to do is pull the little plastic handle and pull the seat up. The little plastic handle releases a latch that keeps the seat anchored. You can find the handle by pushing the cusion up as much as you can and looking under. It's easiest to do this, then grab the handle with your fingers, and then push the cusion down as much as you can, and then pull on the handle. Otherwise, the latch won't come free.
After that, you have the top halves of the rear seats left. For the driver's side rear seat, all you have to do is remove the 2 (I believe it's only 2) bolts that hold it to the metal. Then just push the cusion up and it'll come right out. As for the passenger's side upper cusion, It's a bit more complicated, since it folds down for the trunk pass through. There are 2 bolts that hold the cusion in place (again, if I remember correctly) They are at the folding point of the seat. There are small plastic covers that you have to fold out of the way to get access to the bolts.
I think that pretty much covers it. As for the center console in the rear, there will be several bolts that hold it to the metal of the car. Once you get the seat cusions out, you'll see all of the bolts, and all you have to do is remove these.
If you have anymore questions, feel free to ask.
__________________
Gone, but not forgotten...rest in peace Jon.
|
Linear Mode
