aaron7

Got the bottom of the bezel popped out but it seems like it's attached to the vents both with clips and controls... how do you remove it properly?

__________________
89 MR2 - Body done, built 3sgte w/Greddy TD06 kit, HKS cams, custom everything... car will be ready for next spring!
89 MR2 SC - ALL original down to the floormats
84 Ram D250 2wd - 440ci, Hooker headers, way too much to list
74 CB360 - Custom Mikuni carbs, restored & riding!

minilogoguy18

__________________
New Formula Red 93 BB2: JDM OBD1 H22a/T2W4 Accord Euro R transmission

aaron7

Ahh you DO take the vents out too. I was gonna break something!

Thanks.

__________________
89 MR2 - Body done, built 3sgte w/Greddy TD06 kit, HKS cams, custom everything... car will be ready for next spring!
89 MR2 SC - ALL original down to the floormats
84 Ram D250 2wd - 440ci, Hooker headers, way too much to list
74 CB360 - Custom Mikuni carbs, restored & riding!

jsmooney

hint, unscrew the cable from the hvac control before you unbolt it. Make sure you get it screwed back in properly, or else the cable will move and you will not be able to get it to fully go to heat or cool. I had to re-do it a few times and ended up using superglue (not advised)

I know from experience...

If you pull the thing out before you undo the cable and then put it back on before you bolt the thing back in, make sure the cable isn't twisted

aaron7

Ugh... haven't gotten it out yet and I already broke the tabs on the vents. Off to the bone yard for spare parts!

__________________
89 MR2 - Body done, built 3sgte w/Greddy TD06 kit, HKS cams, custom everything... car will be ready for next spring!
89 MR2 SC - ALL original down to the floormats
84 Ram D250 2wd - 440ci, Hooker headers, way too much to list
74 CB360 - Custom Mikuni carbs, restored & riding!