j_t_heilbrun

I hope some one has ran into this problem. I took my dash out to install the JDM CC. I put it back in and now my headlights, turnsignals, hazards, and gauge lights don't work. My fuel, coolant temp, warning lights, horn, brake lights, and JDM CC all work perfectly.

I did some checking and my wipers work if I ground the combo switch but none of the lights work. I have continuity on the headlights but not the turn signals. I don't seem to have any grounds from the combo switch but when I ground the combo switch, the lights still don't work.

I've checked all the fuses and relays pertaining to the circuit. Also my tack and speedo work. While my coolant temp gauge lights up it doesn't have a signal, the High beam indicator is on, and the CEL is on.

Any ideas???

__________________


You have the right to free speech, as long as your not dumb enough to actually try it.

ludevtec95

you probably forgot to plug in one of the harnesses. check on the drivers side and passenger side under the dash for harnesses that aren't plugged in.

trident

yeah, nearly all of those accessories are on connector C611 and C612 (if you have luminescent gauges) or they are on C610 if you have a regular cluster. I agree with ludevtec 95, you probably forgot to plug in a harness.

j_t_heilbrun

i think I might have plugged one into the wrong spot. I know they are all plugged in, since I have done it 2 or 3 times. I'll make sure they are in the right spots when I get home on Sunday. Any ideas other than that though?

__________________


You have the right to free speech, as long as your not dumb enough to actually try it.