To everyone who ordered a Greddy header - Honda Prelude Forum

Cookout · 06-05-2002, 09:58 AM

I just recieved mine today, but it's a little fishy. They weren't so "polished" everywhere, and they had some scratches and such. What all did you get in the box? I didn't get instructions, but I got 3 bolts and one gasget. Does anyone have any close up pictures, info, advice, or opinions? Thanks...

MikeRenz · 06-05-2002, 10:09 AM

all you need is 3 bolts to connect the upper and lower parts of the header, and a gasket to go in between. Use your stock nuts/bolts for connecting to the engine, and the cat.

Mark94 · 06-07-2002, 12:40 PM

Mike is right, that is all you need for the header. I did receive the directions thought which stated the correct ft/lb of torque measure for the exhaust manifold bolts. Sorry, but I don't remember them off hand.

Don't worry about them not being so polished either because as soon as you turn the car on, they will turn to a blue/purple color.

Just remember to wipe the header free from any finger prints or grease before you turn the car on.

Mark

Fast&furiuslude · 06-07-2002, 02:11 PM

Quote:

Originally posted by Mark94
Mike is right, that is all you need for the header. I did receive the directions thought which stated the correct ft/lb of torque measure for the exhaust manifold bolts. Sorry, but I don't remember them off hand.

Don't worry about them not being so polished either because as soon as you turn the car on, they will turn to a blue/purple color.

Just remember to wipe the header free from any finger prints or grease before you turn the car on.

Mark

yea or itll make this cool looking smoke from your engine