Entangled in wires!!! 4G Si to H22a4 swap - Honda Prelude Forum

Prelude_RCR · 06-05-2002, 09:35 AM

I made a big boo boo. I removed the wiring harness off the H23 without labeling where each connector goes to. *Doh!* Now I'm trying to put it on the new H22a4 I'm swapping in. WHERE DOES EVERYTHING GO?! I have the injector connectors and ALT plugs on one side, so I at least have it orientated correctly. But it looks like I have 3-4 connectors on the timing belt side that still needs a place to go. There are no other connections on the Intake Manifold, I don't think?
Anyone have a clue?...or can show me where each connector goes into?

MikeRenz · 06-05-2002, 09:49 AM

its not that tough...they only really reach to where they should plug in. There should be a little slack in each wire.

Prelude_RCR · 06-05-2002, 10:33 AM

Well, the thing is...I have 3 connectors that have the SAME connector on the end of it. And they can all reach a few certain spots. I'll have to reattach it to the H23a again and hopefully re-label them correctly this time.

BTW, is there a reason why there are some GREEN connectors and some GRAY ones? I have a few that fit in the same connection, but different colors? What's up with that?

Also, do ALL of the H23a wiring harness connectors hook up to the H22a4 motor?

Prelude_RCR · 06-05-2002, 01:44 PM

TTT!!!