swan6464

I have a 95 prelude and friday when I went to leave I had no resistance in the pedal...it just went to the floor and won't come back unless you pull it back by hand. I checked my fluid and it was pretty low, past required levels. so I installed a new slave cause it looked like it had been leaking but after changing that and bleeding it for like 20 min still no pedal. so I install a new clutch master cylinder and bleed it again and still no pedal. Please help....could it be my throw-out bearing. I got the car used with about 140K and prob. put 60-70K on it so i'm not sure it it's the original cluth or not. It didn't slip or anything the day before. Is there anything special about installing the slave???

 

lowrollin82

I am having the same damn problem and I haven't been able to find any help either. I sure as crap hope someone can help us.

TruNinja619

Try to gravity bleed the clutch line from the slave cylinder. Just crack open the bleeder screw and let the brake fluid come out from the bleeder screw for about 5 minutes. Keep an eye on the brake fluid level on the brake master cylinder. Top it off when it gets low.

Hopefully that does the trick. It did the trick for me.

__________________