I have a 1994 prelude si with a SOHC which I am begining to think came from an accord. Just replaced the clutch pressure plate throwout bearing clutch slave cylinder blead all the lines . And it is unpredictable if it will act like it is slipping or grab very well or both from one extreem to another, the clutch came from grip force out of california stage 1 clutch assembly.Today grabing well then stopped at a light and barly would take off and reved up to 5,000RPM before moving very much??????? THen I go to the inner and outer ty rods , just replaced both and now the front end guy says they are to long to adjust and they are identicle to the one that came off?? nOW TO THE o2 SENSOR WHICH IS IN THE EXHAUST MANIFOLD BUT THERE IS NO PLACE ON THE WIRE LOOM TO PLUG IT IN?? will any of the loom from other honda models work on this? Any ideas from you experianced prelude honda owners??? This is my first and so far it is not a good one? PLease respond to
k.pruett@sbcglobal.net Thank you in advance for any info.HHHEELLLPPPPP!!!!
Linear Mode
