BlueLude1

I just installed my energy suspension master bushings kit an took the car to the muffler shop to have some work done. And my buddy who drove it said that it felt kinda wobbly in th rear an when he turned it was more roll that an accord . But what I was wondering is I noticed when I installed the bushings that the camber plate before i removed the bushings had some elsaticity to it cuase u could press it down an it would pop back up but with the bushings I dont have have that it basically just goes to that position if you push it there an then stays.

BTW - I torqued the bolts that run through the bushings and the camber plate to 39 N*m like the Helms says.

Any ideas what it might be?

Thanks
Dane

__________________
B]1992 Prelude VTEC[/B]

* JDM H22 w/ H22 Tranny
* Blue AEM CAI
* ACT HDSS
* Apex'i V-AFC
* Energy Suspension Master Kit w/ Rear Trailing Arm Bushings
* Energy Suspension Motor Mount Inserts
* NGK Blue Wires
* Fiberglass Spoon Replica Lip

j_t_heilbrun

you might try to get it aligned. I'm sure it's not going to be perfect after you pull all the suspension off. Also if you removed the rear toe adjuster that could cause it also.

__________________


You have the right to free speech, as long as your not dumb enough to actually try it.

miamitiger_1

how long did it take you to install? difficult?