Blower motor wiring - Honda Prelude Forum

94LOOD · 01-10-2004, 11:23 AM

EDIT- More pics and ?????'s at the bottom of thread

this is hopefully my LAST thread about the jdm CC, If i have more ???'s i will list them under here

as of now, i have made all the necessary splices for the blower motor to work
however, when i hook it up and start the ca the fan speeds dont turn on.....when i press the fan button i hear an occasional click from the relay but no movement has happened yet

my recirc motor opens and closes fine.....

i havent looked at it too much yet, but im just looking for hints/suggestions......i can post pics of whatever you guys need to see in order to solve this problem

thanks a lot
-MIKE-

Zimmlude · 01-10-2004, 06:56 PM

Did you wire up the transistor properly? Is it installed where the old blower resistor was. It is possible you have a bad transistor. You may also want to check your relay wiring as even with a dead transistor you should still get full speed.

94LOOD · 01-11-2004, 12:08 PM

im 85% sure everything is wired correctly. if i get a chance today ill post pics of where everything is.....

94LOOD · 01-11-2004, 01:43 PM

heres a couple quick snaps i took, if anyone needs to know what something is/where it goes....i can paint on arrows to make it easier

yohan420 · 01-11-2004, 02:16 PM

I think you should put arrows on it .. its pretty scary looking.

94LOOD · 01-11-2004, 04:51 PM

maybe i can do it tonight but i got hella homework...

at least look at the two grounds, are they supposed to be actually grounded to the body like i have them?

Bertico78 · 01-11-2004, 09:32 PM

Quote:

[i]at least look at the two grounds, are they supposed to be actually grounded to the body like i have them? [/B]

I don't know if it makes a difference, but when i did the conversion i hooked all grounds to the thick (about 12gauge) black wire that used to connect to the fan controls in the usdm unit..

94LOOD · 01-13-2004, 08:55 PM

aighty well now.... i got my blower motor to blow all 4 speeds today!

it my next thing i need to do is re-install the evaporator......i removed the 3 prong USDM sensor inside it and replaced it with the similar 2 prong JDM unit......but where/how am i supposed to wire these 2 gray wires now since they dont plug in anywhere

Bertico78 · 01-13-2004, 09:33 PM

you didn't get the harness that connects to the evap. sensor?

One of them is ground which goes to pin #17 in the 20-pin connector in the head unit (this wire along with all other sensor grounds and air mix motor ground all connect into the same pin)

The other wire hooks to pin #9 in that same connector.

I don't know how to tell which is ground or the other since both are gray, i'm sure you'll figure it out or someone will tell you

94LOOD · 01-14-2004, 08:25 AM

im pretty sure there is not anyother harnesses but i will check my box o stuff when i get home from school and work

94LOOD · 01-18-2004, 12:49 PM

the left is my USDM sensor and to the Right is the JDM one, does anyone know which wired is the ground and where to connect the two wires?