marky522

all you have to do is get an actual pry bar (i have a craftsman set) the angle on the end makes it very easy.

Mark

jsmooney

well, the way i figure it, for this job, i am just going to pull the mother****er out of there. who cares if i break it? thats why i got a new one....

i have some cheap breaker bar that my grandfather had, although i may go look at the craftsman tools just to see about it. I do plan on breaking tools for this job. i may just go ahead and use the ratchet that only works half the time because i planned on replacing it anyways. craftman tool are and they seem to carry their name well

marky522

Oh I love craftsman tools, they have never told me no about replacing any tool, and i have gone in 4+ times with the same broken tool in the same day.

Mark

Red4WS

I never took off the lower ball joint, just the radius rod and sway bar. Also if a pry bar does work for getting the axle out try smacking it with a rubber mallet.

__________________
-Klayton

AIM: USA A OK 1
1992 Prelude 4WS Si VTEC

jsmooney

well, as far as axle removal, i will take pics, and then post them as i plan to just grab the end of it and pull til something breaks or it comes out.

jsmooney

when i was pulling out of a friend's driveway the other day, it sounded like i was going up the hill on a rollercoaster due to the clicking of the axle.....