rayslude

i read somewhere it was backwards of what it used to be but that didn't work...someone please help!!

__________________

Qveon

well on your old switch:

92 & 93s & 94s:
wht/yel -- constant 12v
blu/yel -- Turn signal relay for R side
blu/grn -- Turn signal relay for L side

95s & 96s:
Wht/yel -- Constant 12v
grn/yel -- R turn signal
grn/blu -- L turn signal
one point is not used.

Is this what you are looking for?

__________________

rayslude

what pins are the grn/yel and grn/blu wires located on?

__________________

Qveon

you would ask me that...

umm you don't have a harness in front of you for the new councel? If not you are going to have to set your multimeter to test for continunity and press the switch and check each pole till you come up with what you need.

Sorry i do not have this stuff in front of me. i only have wiring diagrams

__________________

Qveon

can you take a pic of the new console switch's backside?

__________________

rayslude

from left to right on the harness backside is: red, red/bk, open, yel/wht, blue, blu/bk

it goes something like that, i'm not 100% if that is how it is

__________________

DoHCxVTeKz

I got it figure out

B4
[Blu/yel]-[Blu/grn]-[yel/wht]-[OPEN]-[red/bk]-[red]

After swap
[red]-[yel/wht]-[OPEN]-[red/bk]-[blu/grn]-[blu/yel]

__________________

rayslude

how do you change which one is open? like how do you pull the pin out in this plug?

__________________

DoHCxVTeKz

get a little tiny size a pin screw drive and polk it in the slot on top of the slot where u plug the switch to which is the bigger slot and push it out with the tiny screw driver.

__________________