Anyone have Pics of there CAI installed? - Honda Prelude Forum

[SUB[EX] · 01-27-2003, 10:46 AM

Does anyone have any pics of there CAI's installed? Im just getting curious. Im thinking there has gota be a better way to get that Air in.

willmbrk · 01-27-2003, 10:53 AM

Here is mine

L-U-R-C-H · 01-27-2003, 10:59 AM

Here are a few pics of mine...

[SUB[EX] · 01-27-2003, 07:59 PM

Nice, so the AEM actually goes all the way into the wheel well? Hmm does anyone have any problems with your tire rubbing on the filter?? I know i dont have too much room under there. Or does it wrap around? I just put a CAI on my car but it really does not go all the way into the hole there. It was a cheap impulse buy. Im tired of looking for a cheap AEM. Man what a difference it makes. I didnt think it would make as much of a difference as it did. Sweet.

yield · 01-27-2003, 08:12 PM

THe tire won't be a problem. The only fitment issue is that you have to open the hole a tad to get the pipe through, which incidently, you don't need to do with an Iceman intake.

willmbrk · 01-27-2003, 10:37 PM

I didn't have to oepn the hole with my AEM CAI. It fit in perfectly.

4bidden · 01-27-2003, 10:50 PM

ViZ · 01-27-2003, 11:19 PM

4bidden · 01-28-2003, 03:10 AM

Sorry for the OT post...

Viz, is your 'lude an S model? I don't see the ABS in your bay....

Satan_SRV · 01-28-2003, 05:11 AM

Quote:

Originally posted by 4bidden
Sorry for the OT post...

Viz, is your 'lude an S model? I don't see the ABS in your bay....

Haha I already hit him up on AIM to ask about that. Only the hardcore notice! Yeah it's a S to H22a swap so no ABS. I was like did you remove your ABS!?

ps my old Engine Bay

ViZ · 01-29-2003, 06:26 AM

hehe yeah good eyes on that one.. it Was a base model but i dont need no stinkin abs anyway

L-U-R-C-H · 01-29-2003, 08:25 AM

Hey I am switching to a Polished CAI and I have a little problem around the hole where the intake goes down. Here is a pic:

Did you guys use some kind of rubber to put around the sharp edges of the hole? I don't want my new one getting scratched.

willmbrk · 01-29-2003, 08:28 AM

How did you guys install yours cause mine fit in no problem without cutting the metal?

L-U-R-C-H · 01-29-2003, 09:08 AM

I had to cut mine a bit with a pair of metal cutting scissors.

Forbidden · 01-29-2003, 09:51 AM

I believe there was a thread about this and people were saying that if you have a 92-93 the hole is not big enough but the 94+ the hole is bigger so you don't have to cut anything.