AGX + GC problem - Honda Prelude Forum

MidNKight-lude · 08-12-2002, 09:40 PM

ok i am askin the 4th gen first, cause i know most of you guys are running the same setup. Here the deal about a week and half ago, i tried to have honda install my shock and coilover. i had gotten the coil over used so there was no instruction. I have the older ground control, so it double perch. If i didn't get a GC them, wat ever that not my problem. the problem is that when we, me and the mech. at honda, tired to install the coil over on the shock, it lifted my car. we dump the coil over to the bottom, and it raised the car higher then stock. I used that lil polyeuathiain top thingie on the coil over. Does any1 have picture of the setup, or what they used to install it, like parts wise

thank for readin my long post

jgprelude · 08-12-2002, 11:09 PM

Were you trying to reuse the stock metal dust cover on the shock. It will hang on the top of the shock, and your car will look really jacked up no matter how low you set the coilovers.

MidNKight-lude · 08-13-2002, 12:17 AM

we only did the front, and no we didnt' reuse the dust cover for the front. i am thinkin the rubber/polyurthanine top is the problem

Si4WS · 08-13-2002, 12:25 AM

You need to cut the bump stop almost in half, height wise. I can fax you the GC instructions tomorrow. Now you have me worried, I have the current GC and I just ordered the KYB AGX.

MidNKight-lude · 08-13-2002, 01:09 AM

i dont' believe it is the kyb, but if it is, i am gettin them replace

blakdeth77 · 08-13-2002, 07:37 AM

GC says on their website what shox work best wif their springz y0. =)

Si4WS · 08-13-2002, 08:17 PM

Quote:

Originally posted by blakdeth77
GC says on their website what shox work best wif their springz y0. =)

And the KYB AGX are recommended.