AEM Cam Gear - Honda Prelude Forum

preludegen4 · 08-11-2002, 06:11 PM

Hi, I'm new to this forum.

I have a 95 Honda Prelude Si (auto). These are the mode that I have so far: Cold air intake, DC Header, testpipe, 2.25 custom pipe, OBX muffler, OBX Pulleys, OBX Plug Wire, Val bypass and a new pair of AEM Cam Gear.

I adjusted my cam gear: +2 intake and -2 exhaust. When my car take off I felt something hold it back (slower then before) ultill after 2400 RPM then it peak up like normal. I Even try to ship it manually D1-D2-D3-D4 but it still happen! Does anybody have this problem before? Does this mean good or bad for my car? If bad, what should I adjust my intake or exhaust?

I did try to put Cam Gear both in 0 degree. There is no problem. If I do that, that doesn't make sense because buy Cam Gear no adjust no power gain then why whould I buy it for right.

Mr Clean Lude · 08-11-2002, 06:53 PM

Sorry, I don't know the answer. I was just wondering how your car ran before th cam gears with the mods you have? Because i have an Auto too, and just wanted to see if you have any timeslips, or any opinion on how the car runs, and the quickness. thanks...