hey guys.. Just wonder... I just installed my JDM fogs this past weekend... and i've read two variations as to what socket # on the fuse pannel that I can plug the 2 1-pin wires into...
here's from the PO.com FAQ...
Quote:
|
Now look under the dash, where you poped off all the covers. You will see a bunch of fuses and connection ports. Now take the brown plug off the interior wire harness that has the two red wires and connect this in port #2. Take the other brown plug which has the white/brown wire and put it in port #5. You need to slide these plugs in until they snap in place. Make sure that they slide all the way in!!
|
and here's from the vtec.net instruction..
Quote:
There are 4 optional connectors in the fuse/relay panel on the driver's side. Their functions are as follows:
1.+12V When ignition is in the "ON" position.
2.+12V When dash lights are on (i.e. parking lights OR headlights are on).
3.+12V When ignition is in the "II" position.
5.+12V ALWAYS.
(I'm sure about 2,5 and pretty sure about 1,3 but you might want to double check).
Connect the main power( to the fused link) to option connector #5. You can connect the other connect to #2 if you want to operate the lights only when the other lights are on or to #1 if you want to be able to operate the fogs anytime the engine is on. This also controls when and how the switch is illuminated.
|
so is the main power cord the one with the two red wires? and will it work if I plug that into socket #5 and the other wire (the white wire with a brown dot) into #3 or #1?
cuz right now I have an other cable plugged in my #2 socket... not sure what it is.. but I guess it's the aftermarket alarm... so.. if you guys could help me out I'll be very greatful...
Linear Mode
