R34 front end - Honda Prelude Forum

NoelJ · 03-20-2002, 06:59 PM

What do you guys think?
http://www.importfan.com/product.asp?3=728

PreludeVTEC01 · 03-20-2002, 07:03 PM

thats a really nice front end...i wanted it at one time, but its hard to find one to fit good...and it will cost u a arm and leg and then painting it

but best of luck to ya..also what sides and rear do u want to run with it? it will be hard to get the sides and back to match right

A247Sleeper · 03-20-2002, 07:05 PM

is that the same as the vis octane?

LuDeGirL1004 · 03-20-2002, 07:15 PM

Yes, that's the same as the Octane.

AncientPC · 03-20-2002, 07:39 PM

It'll look better with an intercooler filling up the gap in the front.

krnnamja83 · 03-20-2002, 08:54 PM

oh my mother freakin god....they are selling lenses for $150!!!
since when did plastic shaped in a box started costing $150!!!

03-20-2002, 09:13 PM

well its NISMO....

NoelJ · 03-20-2002, 09:47 PM

The kit caught my eye, but I have no idea what would look good with it. Is the quality of GTP any good? I hear you have to shave and file and do all kinds of stuff just to get it to fit. My buddy has the bomex on his integra and it cracked where the wheel is. This kit is $350 and then $200+ shipping?! I think they're seriously jacking up the shipping cause it's $200+ anywhere. Dunno, probably won't get it.

makavelli1227 · 03-20-2002, 10:14 PM

IMO i really don't like it....a little to wild and carzy for my lude...if i ever get a R34 then it would look better.

WBB6 · 03-20-2002, 10:16 PM

I think it looks awesome, but it will probably sit like 3" off the ground with your stock suspension!

soon2bsh · 03-21-2002, 01:42 AM

umm...becareful with this kit...the one i got from vis DIDNT EVEN FIT on the car!
the bodyshop had to do MAJOR work to the bumper to fit.
so becareful.....they do have nice cf hoods, kinda wavy though.

ShadowSonic · 03-21-2002, 05:50 AM

I got my front sitting at home but IT SUCKS its very low... so if your thinking about lowering the car ha, dont go more than 1.3 inches im telling you or you will bottom out everywhere, and yes you will need some work to make it fit

soon2bsh · 03-21-2002, 03:42 PM

haha, some work is an understatement.
the bumper was all warped esp. the top.
it was warped downward and the sides were uneven.
the bodyman said it was due to pulling the bumper from the mold too early, and the fiberglass and resin had not fully cured, that and the bumpers are made in china and a couple of monthes in hot ass cargo boxes all equal....profits for vis and crappy bumpers for us.

ShadowSonic · 03-21-2002, 04:38 PM

But i didnt get mine from VIS thank god ... *SAY NO TO VIS*

soon2bsh · 03-23-2002, 01:42 PM

well unless its a copy then it was from VIS...they are the supplier of that kit.....although if it is anyway...it would probably be much better.
i found a guy who has copies of the octane kit for most cars....and the quality is actually very good....better then vis for sure.