UEnvyMyStyle

hey im lookin to upgrade the factory speakers in the front... im looking to get coaxials, NTPOG.ORG says for 5 1/4 you just have to drill new holes, can anyone verify that or give me some tips, also what speakers does everyone reccomend

Sazaks

I installed some 6.5 component JBL GTO605C and they fit perfect! Just a little trimming(almost nothing) of the door speaker basket was needed and even the tweeter fit in to stock location using the stock hardware. I would say it's an excellent price/quality speaker and I would recommend them to anyone.


http://www.jbl.com/car/product.asp?p...er=GTS&cat=COS

Marc

UEnvyMyStyle

did these require cutting, i really dont wanna cut or remove the door pannel...?

Sazaks

Removing the door panel is really not that hard (3 screws) and your going to have to do it to replace the factory tweeter. I suppose you could replace the bottom speaker without doing it....but I don't see why you would.

Check out the picture of the install:
Picture

UEnvyMyStyle

you didnt have to cut for the 6.5??? also how did u run the wire through the door, these are amped correct???

Sazaks

I didn't have to cut anything around the perimeter but I did have to trim (just a little with a utility knife) the plastic speaker basket to clear the bigger magnet. As far as the speaker wire goes...I used the stock wirering...changing it would be a big PITA!!

ludefoshizzle

mb quarts fit PERFECTLY 6"

Lewd Lude

i fit 6.5 focals with minimal cutting...speaker grilles fit over them with no problem

__________________


the things you own, end up owning you

Daemione

8 screws, actually, and a bunch of plastic clip/rivets.

But if you're getting co-ax's there's no need to touch the tweeter, or remove the door panel. Unless you're running new wire to the door (a PITA).

__________________
--- This message was not sent from a phone ---