ReefAIR

I am planning on buying a new shift Knob and I was wonding has anyone taken off the little plastic peice that holds the boot to the stock shifter knob.... and what does it look like after?? does anyone have pics of this?????

Thanks..

Chronus114

Actually I'm interested in this as well, I bought my 2000SH with 11K Km's on it, and the original owner installed a "personal" shift knob, and ya, that plastic bit doesn't fit over the "ball" under the knob (man that sounds bad).

Chronus114

Hey Reef, didn't notice when I replied to this that you were in Ottawa, cool.

ReefAIR

That's funny.... Good Old Ottawa..

KENLUDE97

I just did mine but i don't know how to post the pictures If anyone knows how let me know!

Placid

-take off the centre console
-from the underside of the shift boot, cut the zip-tie and remove the stock plastic ring
-turn the boot in about an inch and use a zip-tie/rubber band to pinch it together
-slip the boot back over the stick and it should be snug

btw...check out www.hondaprelude.to when it's back up and running

__________________

Toronto Prelude Club
www.hondaprelude.to

Chronus114

Cool thanks

ReefAIR

Thanks Man... So when the torontoprelude.ca is back and running is there going to be a link on there to show you how to do it.. (And is there any Pixs)...

iLCaPo

LOL... that sounds too easy...... i was tring to pull the damn thing off with FORCE...it was never succesfull.....lol

ImagePree

Joon's shift boot:

__________________
See ...